SECTION III USE
Hydraulic system
All the oil utilized is taken from the gearbox and filtered thorugh an interchangeable
cartridge filter, which is supplied with a pressure switch that signals its clogging
then sent under pressure to the various loads by two hydraulic pumps mounted in
tandem.
If the tractor is equipped with a front PTO, the oil used to operate the hydraulic
clutch is taken from the main circuit via an electro-hydraulically operated valve
from which it is delivered to the clutch thrust bearing. From the clutch, a transfer
pump returns the oil to the drain line and back to the gearbox.
Hydraulic system pumps located on the left side of the tractor.
50
CAUTION: WHEN OPERATING STATIONARY P.T.O. DRIVEN EQUIP-
MENT (FOR EXAMPLE WATER PUMP, ETC.), DO NOT LEAVE THE
TRACTOR SEAT UNTIL ALL GEAR LEVERS ARE IN “NEUTRAL”, THE
PARKING BRAKE IS FULLY ENGAGED, THE CAB DOOR LOCKED
WITH THE KEY AND THE TRACTOR AND IMPLEMENT WHEELS ARE
CHOCKED.
DANGER: FLUIDS THAT ARE UNDER PRESSURE CAN PENETRATE
HUMAN TISSUE CAUSING SERIOUS INJURY. IT IS RECOMMENDED
TO ALWAYS STOP THE ENGINE AND RELIEVE THE PRESSURE BE-
FORE CONNECTING OR DISCONNECTING LINES.
CAUTION: ALL IMPLEMENTS MOUNTED TO THE TRACTOR MUST
BE SAFELY ATTACHED.