SECTION III USE
Engine
Precautions for optimum engine performance
–
Use the prescribed engine oil and always verify that the oil pressure
pilot lamp is operating.
–
Use clean fuel free of impurities and water.
–
With the engine running always make sure that the water temperature
is correct.
–
Check the exhaust gases to see if the engine is in good working condi-
tion.
–
Regularly perform the maintenance operations as indicated in the
Maintenance Schedule Chart.
- first 50 work hours
The tractor is delivered to the customer ready for use under full power.
Nevertheless, FOR THE FIRST 50 HOURS' RUNNING,itis
recommended that the tractor not be run at maximum load for long periods
so as to enable the piston rings and the various moving parts to bed in
properly.
During this period we strongly advise to refrain from running the engine at
low r.p.m.s or high r.p.m.s for a long time when in neutral, as either
situation is harmful and would result in engine components becoming
bedded in such a way that MAXIMUM PERFORMANCE will not be
guaranteed.
17
IMPORTANT: THE SAFETY SEAL ON THE ENGINE GOVERNOR IS
APPLIED BY THE MANUFACTURER AND ENSURES THAT THE
POWER OUTPUT OF YOUR TRACTOR DOES NOT EXCEED THE DE-
CLARED AND APPROVED VALUE.ANY TAMPERING WITH THIS
SEAL ON THE GOVERNOR WILL VOID THE WARRANTY FOR THE
ENTIRE TRACTOR WITH IMMEDIATE EFFECT.
DANGER: DO NOT USE AEROSOL CANS OF STARTING AID ON
TRACTORS WITH THE THERMOSTART CONNECTED TO THE ELEC-
TRICAL SYSTEM. ETHER COMBINED WITH THERMOSTART CAN
CAUSE AN EXPLOSION WITH DAMAGE TO ENGINE, PERSONAL IN
-
JURY, OR BOTH.
To Next Page
Loading...
Need help?
General
