SECTION V MAINTENANCE
Maintenance of hydraulic power-lift
The hydraulic power-lift uses the same oil as the gearbox, which should be
checked and changed according to the schedule listed in the related
section.
Maintenance of the 3-point linkage
Rear 3-point linkage
Furthermore, grease the two lift rods and the stabiliser rods through the
grease nipples indicated with the arrows in the figure below at the intervals
specified in the maintenance schedule.
Rear 3-point linkage
147
CAUTION: APPLY THE PARKING BRAKE AFTER THE ENGINE HAS
STOPPED AND BEFORE LEAVING THE TRACTOR.
NOTE: When adjusting the length of the top link of the 3-point hitch, take
care that it does not come apart and ensure that a sufficient length of the
threaded end of the turnbuckle is screwed into the turnbuckle housing to
withstand the tractive force applied when working.