10
Member of Exel group
DRT582165110
A - 2023/03
1.2.1.3. Additional box Evo+ marking - ATEX nameplate
The additional box Evo+ is not an ATEX box. It is an associated box that can be connected to an ATEX board
installed in an ATEX zone. There are therefore ATEX and non-ATEX versions.
Description
Sames Code Manufacturer's brand
STAINS FRANCE Place of production of the equipment.
Cyclomix
®
Evo box
Product name
CE: European conformity
II (2) G
: Use in explosive areas
II: Group II
(2): Category 2
Surface equipment intended for use in environments where explosive atmospheres due to gases, vapors, mists are
likely to occur occasionally during normal operation.
G: Gas
Ex Ex: Marking of conformity to European standards
[ia Gb] ia: Intrinsic safety
Gb: Equipment protection level (zone 1 gas)
IIB IIB: Reference gas for equipment qualification
UKCA UKCA: UK Conformity Assessment
Marking required for certain products placed on the market in Great Britain (England, Wales, Scotland) from
January 2021
Type Model of the box
Ref Reference specific to the equipment manufacturer.
Série/Serial
Number given by SAMES
The first 2 digits indicate the year of manufacture
Voltage
Voltage of the Cyclomix
®
Evo
P air Maximum air pressure
Phase Single-phase
Frequency 50/60Hz > Mains frequency
Amperage Maximum current consumption
This logo means that your used product must be disposed of in an appropriate recovery and recycling facility.
NE PAS DÉBRANCHER
SOUS TENSION
DO NOT DISCONNECT
WHILE POWER IS ON
Failure to follow this safety instruction could result in death or serious injury safety instructions.
To Next Page
Loading...