70
Member of Exel group
DRT582165110
A - 2023/03
2.5.10. Use the Batch function
In order to allow a good dosage of the various
products, it is imperative that the volumes
measured by the flowmeters are very precise. It is
therefore necessary to be able to regularly check
the accuracy of the flowmeters.
In order to be able to carry out later touch-ups, it
may also be necessary to take the different
products separately in order to mix them at the
time of the touch-up.
..
The Batch function can be accessed directly from the main menu.
After selecting the Batch mode, select the recipe from which you wish to take the products.
Before sampling the products, it is necessary to fill the circuits with each product.
On the other hand, before leaving the calibration, it will be necessary to flush the circuits.
For each phase, follow the instructions on the screen:
Test valve B
Test valve A
Product B
(use a Ø 4mm hose)
Product outlet A
(use Ø 4mm hose)
To Next Page
Loading...