65
Member of Exel group
DRT582165110
A - 2023/03
2.5.6. Priming
The priming is the phase that consists in filling the supply circuits of the sprayers with mixed paint ready to be applied.
Ready to apply means at the right ratio and the right mix.
The priming phase is managed automatically by Cyclomix
®
Evo.
This means that the Cyclomix
®
Evo will first fill the circuits between the color changers and the mixing block and then
fill the mixed circuit.
Depending on the products present in the machine at the time of the recipe call, the filling of circuits A, B or C will be
carried out or not.
The volume of priming is automatically calculated by Cyclomix
®
Evo on the basis of the pipe dimensions indicated in
the configuration.
The volumes included in the different elements (filter, regulators, flow meters, mixer, etc.) are already taken into
account by the machine.
To these volumes will be added the volumes corresponding to the hoses between the Cyclomix
®
Evo and the
sprayer(s) as well as any hoses added between the mixer and the 2-gun block or between the color changers and
the flow meters.
It is recommended to always perform the priming phase with the gun nozzle in place.
Without the nozzle, the flow rate could be too high and result in an insufficiently homogeneous mixture.
To Next Page
Loading...