138
Member of Exel group
DRT582165110
A - 2023/03
• Step 2:
Later, if the user needs a temperature sensor, he
will have to add an analog card (ANAB).
• After wiring this new card, the user will be able to
restart his box.
• At start-up, this is the message that should be
displayed.
• Step 3:
After acknowledging this message, the user will be
automatically redirected to the maintenance
screens (opposite) to configure his network.
• Step 4:
The configuration on the screen no longer
corresponds to its installation.
To update it, the user must:
• Press the scan button, a confirmation message
appears.
• Press YES.
To Next Page
Loading...