63
Member of Exel group
DRT582165110
A - 2023/03
It happens that on the technical data sheets of the products the ratio is declared in shares. By pressing the button
''Parts'', it is possible to enter this information directly via a specific screen.
To define by yourself the injection frequency, uncheck the box
''Autonomous injection'' to allow access to the configuration page.
It is also possible to customize the flushing phases.
It is possible to create up to 20 flushing steps.
If the box ''Autonomous flushing'' is unchecked then a page with 4
flushing steps appears.
If the 4th step is created then a new page with 4 steps appears.
2.5.4.2. Flushing strategy
In order to optimize the flushing process, each stage can be configured with a different flushing strategy.
• The product strategy allows to circulate a product during a given time or a defined volume.
• The air chop strategy allows to rinse with a mixture of air and solvent.
This mixture produces a mechanical action that improves flushing while using a minimum amount of solvent.
• To do this, it is necessary to define the time during which the Cyclomix
®
Evo sends the solvent, then the air
injection time and finally the number of air/solvent cycles that will be repeated.
It is also possible to insert a time delay between the product and air injection periods. This delay is necessary
in the case where the solvent pressure is higher than 6 bars, it allows to make sure that the product pressure
inside the circuit is lower than the air pressure, generally at 6 bars.
• The delay strategy: during this phase all the control valves are closed to let the solvent have a chemical action
on the paint. This will allow the solvent to dilute the paint on the pipe walls.
2.5.4.3. Create, duplicate or delete a recipe
These 3 functions are accessible from the button located at the top
left of the recipe screens.
To Next Page
Loading...