Samson TROVIS 5500 - Page 112

112 EB 5573-1 EN
Operational faults
When Modbus is activated and, at the same time, the dial-up in case of error is released, the
connection with the building control station is established rst, and then the text message is
sent. If the rst attempt to connect to the building control station fails, the controller tries
again until the programmed number of redialing attempts has been exhausted.
In Germany, the access numbers (PA6 > P08) of the SMS service center are currently:
− D1: 0171 252 1002
− Cellnet (UK): 0044 786 098 0480 – routes to mobile networks D1, D2 and E-Plus
Add “0” to the number when dialing from a telephone extension. The mobile phone number
(PA6 > P09) must be entered as follows: 49 xxx yyyyyy, where xxx stands for 160, 171 or
any other valid dialing code and yyyyyy represents the specic mobile phone number.
Functions WE Conguration
Text message 0 CO6 > F08 - 1
Modem 0 CO6 > F03 - 1
Automatic conguration 0 CO6 > F04 - 1
Parameters* WE Parameters: value range
Modem dialing pause (P) 5min PA6 > P04: 0 to 255min
Modem timeout (T) 5min PA6 > P05: 1 to 255min
Number of redialing attempts (C) 15 PA6 > P06: 1 to 255
Access number – PA6 > P08: Max. 22 characters; 1, 2, 3, …, 9, 0;
- for end of a string; P for pause
Mobile phone number – PA6 > P09: Max. 22 characters; 1, 2, 3, …, 9, 0;
- for end of a string; P for pause
* See section10.3