EB 5573-1 EN 19
Operation
After programming all public holidays:
q Select 'Back'.
¼ Exit the public holiday setting.
Turn the rotary switch back to
(operating level).
Note:
Public holidays that are not assigned to a specic date should be deleted by the end
of the year so that they are not carried on into the following year.
2.6.3 Vacations
The system runs constantly in reduced mode during vacation periods. A maximum of ten va-
cation periods can be entered. Each vacation period can be separately assigned to the heat-
ing circuits HC1, HC2 and DHW circuit or to all control circuits.
Parameters WE Value range
Vacation period --.-- - --.-- 01.01 to 31.12
Turn the rotary switch to (special times-of-use). The party
timer for the rst control circuit is now selected.
q Select 'Vacations'.
¼ Start the vacations setting. The rst vacations setting is
now selected. --.-- - --.--.is displayed if no vacations (de-
fault setting) have been programmed.
q Select --.-- - --.--, if applicable.
To Next Page
Loading...