Samson TROVIS 5500 - 2 Operation; Operating Controls; Rotary Pushbutton; Rotary Switch

EB 5573-1 EN 7
Operation
2 Operation
The controller is ready for use with the default temperatures and operating schedules. On
start-up, the current time and date need to be set at the controller (refer to section2.4).
2.1 Operating controls
The operating controls are located in the front panel of the controller.
2.1.1 Rotary pushbutton
*
Rotary pushbutton
Turn [q]:
Select readings, parameters and function blocks
Press [Û]:
Conrm adjusted selection or settings
2.1.2 Rotary switch
The rotary switch is used to set the operating mode and the relevant parameters for each
control circuit.
Operating level
Operating modes
Manual level
Day set point (rated room temperature)
Night set point (reduced room temperature)
Times-of-use for heating/DHW
Special time-of-use
Time/date
Settings