Samson TROVIS 5500 - Setting Special Times-Of-Use; Party Timer

EB 5573-1 EN 17
Operation
2.6 Setting special times-of-use
2.6.1 Party timer
Rated operating in the corresponding control circuit (HC1, HC2 or DHW) is started or contin-
ued for the time period set in the party timer. When the party timer has elapsed, the party
timer returns to --:--.
Parameters WE Value range
HC1 party timer --:-- h 0 to 48h; in steps of 15 minutes
HC2 party timer --:-- h 0 to 48h; in steps of 15 minutes
DHW party timer --:-- h 0 to 48h; in steps of 15 minutes
Turn the rotary switch to (special times-of-use). The party
timer for the rst control circuit is now selected.
q Set party timer of another control circuit, if required:
– Heating circuit HC2
– DHW heating
Î Only those control circuits are available for selection
which can be controlled by the selected system.
¼ Activate editing mode for the party timer. The party tim-
er is now in the editing mode (inverted display).
q Extend day operation as required (in steps of 15 min-
utes).
¼ Conrm setting.
After setting the party timer:
Turn the rotary switch back to
(operating level).
Note:
Party timer runs down in steps of 15 minutes.
