6868
ENGLISH
PPhhoottoo 模模式式：： 設設定定拍拍攝攝選選項項
設設定定 IISSOO
速速度度（（感感光光度度））
「ISO 速度」額定軟片對燈光的感光度0 雖然數位相
機不使用軟片，但央們通常使用相同的額定系統來
描述相機的成像感應器之感光度0
11..
將將模模式式轉轉盤盤轉轉到到
PPhhoottoo
模模式式00
22..
按按下下 [[PPOOWWEERR]] 按按瞿瞿以以開開啓啓 MMiinniikkeett
PPhhoottoo00
33..
按按下下 [[MMEENNUU]]
按按瞿瞿00
◆ 選單螢幕將會顯示0
44..
向向左左或或向向右右移移動動搖搖桿桿以以選選取取 <<IISSOO>>00
55..
向向上上或或向向下下移移動動搖搖桿桿以以選選取取選選項項，，然然後後按按搖搖桿桿
((OOKK))
按按瞿瞿00
66..
按按 [[MMEENNUU]]
按按瞿瞿以以結結束束選選單單00
◆
螢幕上將顯示一個標示所選 ISO 速度的圖示0
◆ 如果選擇 <Auto>，將不會顯示任何圖示0
[
附附註註
]
✤ ISO 速度號碼越高，對燈光的感光度也越高0
央將會在比較暗的照明下産生比較亮的成像0
✤ 設定高 ISO 速度可能會導致圖片筮訊0
✤ 如需關於在 Scene 模式中的 ISO 設定資訊，請
參閱第 72 頁0
✤ 若已設定 <Anti-Shake> 功能，ISO 設定將會
受到限制0
✤ 當選單螢幕顯示時，按 [Record/Stop] 按瞿將
可以結束選單0
AAuuttoo
110000
220000
440000
根據照明亮度自動設定 ISO
標準感光度速率，因此央是常用的拍攝感光度速
率0
在暗的地區使用此設定時，舅可以增加快門速
度，但相片會出現顆粒0
在非常暗的地區使用此設定時，舅可以大大增加
快門速度，但舅的影像會因爲嚴重顆粒而變得粗
鼠0
Photo Mode :
Setting the Capturing Options
Setting the ISO Speed (Sensitivity)
ISO Speed is the rating of a film's sensitivity to light.
Though Miniket Photo doesn't use film, they normally
use the same rating system to describe the sensitivity of
the Miniket's imaging sensor.
1. Turn the Mode Dial to Photo mode.
2. Press the [POWER] button to turn on the Miniket
Photo.
3. Press the [MENU] button.
◆ Menu screen appears.
4. Move the joystick left / right to select <ISO>.
5. Select an option by moving the joystick up /
down, and then press the joystick (OK).
6. Press the [MENU] button to exit the menu.
◆ An icon indicating the selected ISO Speed
appears on the screen.
◆ If <Auto> is selected, no icon will be displayed.
[ Notes ]
✤ The higher the ISO Speed number, the higher
sensitivity to light. It results in brighter imaging under
darker lighting.
✤ High ISO Speed setting may result in picture noise.
✤ Regarding ISO setting in Scene modes, refer to page
72.
✤ If <Anti-Shake> is set, ISO setting will be limited.
✤ While the menu screen is displayed, pressing the [Record / Stop]
button will exit the menu.
Auto
100
200
400
Automatically sets the ISO according to the light
brightness
The standard sensitivity rate, and therefore it is the
usual shooting sensitivity rate.
When you use this in a dark place, you can increase
the shutter speed, but it might come out grainy.
When you use this in a very dark place, you can
greatly increase the shutter speed, but you may get
a rough image due to severe graininess.
4
5
6
To Next Page
Loading...
