Need help?Do you have a question about the Samsung OfficeServ 100 and is the answer not in the manual?
General| Brand | Samsung |
|---|---|
| Model | OfficeServ 100 |
| Category | Telephone System |
| Language | English |
Explains the manual's objective and target audience for the OfficeServ 100 system.
Highlights critical safety instructions to prevent severe injury or death.
Provides instructions to prevent system damage or service failures.
Details environmental and location criteria for installing the OfficeServ 100 system.
Describes the maximum station and trunk capacity based on board combinations.
Provides steps for physically mounting the Basic KSU unit to a wall or backboard.
Explains how to attach the Expansion Cabinet A or B to the Basic KSU.
Outlines procedures for proper system grounding and associated safety precautions.
Describes how to connect the system to the Main Distribution Frame (MDF).
Covers battery selection and installation procedures for power failure backup.
Explains the installation of the 30-channel ISDN PRI interface card.
Guides on installing the ISDN BRI interface card.
Details the installation of the Main Control Processor 1 card.
Provides steps for connecting power and initial system checks.
Describes how to verify installed cards and system configuration.
Guides on connecting loop start lines via MDF.
Guides on connecting digital phones to DLI ports.
Details connecting single line telephones to SLI ports.
Describes connecting IP telephones via Ethernet LAN.
Guides on programming the system via PC using serial or LAN interface.
Details how to program the system remotely using modems or LAN.
Provides steps for replacing software on the MEM3 card.
Explains operating multiple systems as a single unit using Q-SIG.
Lists basic Q-SIG networking functions like Intercom, Incoming, Outgoing calls.
Outlines the steps for configuring networking functions.
Defines required system components and programs for networking.
Explains how to unify phone number systems for seamless networking.
Details programming for routing incoming and outgoing calls.
To Next Page
