Santerno Sinus M - 11.3 Monitoring fault condition; Monitoring current fault status; Fault History Monitoring

11-5
11.3 Monitoring fault condition
 Monitoring current fault status
Group Display Parameter Name Setting Range Default Unit
Drive group
nOn [Current Fault Display] -

Fault occurred during operation is displayed in nOn.

Up to 3 kinds of faults can be monitored.
 This parameter gives information on fault types and the operating status at the time of the fault. Refer to
Page 11-5 for keypad setting.
Fault
types
Frequency
Current
Accel/Decel
Information
Fault during Accel
Fault during Decel
Fault during constant run
 Refer to Page 14-1 on fault types.
 Fault History Monitoring
Group Display Parameter Name Setting Range Default Unit
Function
group 2
H1 [Fault history 1] -
~ ~
H5 [Fault history 5]
H6 [Reset fault history] - 0 ~ 1 0

H1 ~ H5: Up to 5 faults information are stored.
 H6: Previous fault information stored in the code H1 through H5 are all cleared setting “1”
H6.
 When a fault occurs during operation, it can be monitored in nOn.