Santerno Sinus M - 5.3 Moving to other groups; Drive group; Function group 1; Function group 2

5-3
5.3 Moving to other groups
 There are 4 different parameter groups in Sinus M series as shown below.
Drive group
Basic parameters necessary for the inverter to run. Parameters
such as Target frequency, Accel/Decel time settable.
Function group 1
Basic function parameters to adjust output frequency and
voltage.
Function group 2
Advanced function parameters to set parameters for such as
PID Operation and second motor operation.
I/O (Input/Output)
group
Parameters necessary to make up a sequence using Multi-
function input/output terminal.
 Moving to other parameter groups is only available in the first code of each group as the
figure shown below.
Moving to other groups using the Right (

)
key
Moving to other groups using the Left () key
Function
group 1
Function
group 2
I/O group
Drive group
*
Function
group 1
Function
group 2
I/O group
Drive group
*
* Target frequency can be set at 0.0 (the 1
st
code of drive group). Even though the preset value is
0.0, it is user-settable. The changed frequency will be displayed after it is changed.
I/O group
FU group 2
FU group 1
Drive group