SANY SY95C - Page 34

3-6
MACHINE CONTROLS
SY95C Excavator OMM
Item Home Screen Display Function
1
Time and date
Displays the current date (YY/MM/DD) and time (HH/MM/SS). See “Date and Time
Setup Screen” on page 3-14.
2
Preheat icon
When this icon illuminates, the engine is in preheating mode. See “Cold Weather
Engine Starting” on page 4-14.
3
Battery charge icon
This icon will illuminate to indicate the battery is discharging when the engine is
running, and will be illuminated with the key switch in the ON position when the
engine is not running.
4
Throttle position
Displays the current throttle position from 0–100% in 10% increments. It is adjusted
with the throttle control dial. See “Throttle Control Dial” on page 3-20.
5
DPF regeneration
inhibit icon
Regeneration is inhibited when this icon is illuminated.

See “Diesel Particulate Filter (DPF) Screens” on page 3-14.
6
Fuel level gauge Displays the fuel level.
7
Operating hours Displays the total number of machine operating hours.
8
Engine coolant 
temperature gauge
Displays the engine coolant temperature.
9
Engine oil pressure alarm When the oil pressure is low, this icon illuminates as a warning.
10
Coolant temperature alarm When the coolant temperature is high, this icon illuminates as a warning.
11
Function list (folder) icon Press the button below the icon to access the Function List screen.
12
High/Low travel speed icon
Press the button below the icon to select high travel speed (rabbit icon) or low
travel speed (turtle icon).
13
Auto idle icon
Press the button below the icon to enable or disable the auto idle function. This
function will reduce fuel consumption and noise levels during periods of inactivity.
14
Work mode icon
Displays the machine work mode. The machine is equipped with the

Standard (S) working mode only.
15
Maintenance prompt icon
The blue umbrella icon will illuminate if any scheduled maintenance is due.

See “Maintenance Information Screen” on page 3-5.
16
Failure code
Failure code illuminates when an abnormality is detected. See “Failure Codes
Screen” on page 3-10.
17
Failure information icon
Indicates that an abnormality has occurred.

See “Failure Codes Screen” on page 3-10.
18
Severe failure alarm icon
When this icon illuminates, shut down the engine immediately to prevent severe
damage to the machine. Check for failure codes that may be displayed. See
“Failure Codes Screen” on page 3-10. Contact a SANY dealer for further
information.
19
Operating mode icon
Indicates the selected work tool or equivalent one-way or two-way operating mode.
See “Operating Mode Screen” on page 3-12.