SANY SY95C - Park the Machine; Parking the Machine on a Grade

MACHINE OPERATION
4-29SY95C Excavator OMM
Park the Machine
1. Move the machine to a solid, level surface.
0002279
Figure 4-67
2. Lower the bucket and dozer blade to the ground.
3. Move the throttle control dial to MIN (low idle). Run
the engine at idle for 5 minutes to cool it down.
0002764
Figure 4-68
4. Move the hydraulic control lever (1) to the locked
(closed) position (2).
5. Turn the key switch to OFF and remove the key.
6. Close the windows and cab door.
7. Turn the battery disconnect switch to OFF.
8. Close and lock all doors.
Parking the Machine on a Grade
0002323
Figure 4-69
CAUTION
Avoid parking the machine on a grade when
possible. Machine rollover can cause injury.
If it is necessary to park the machine on a grade:
1. Firmly set the bucket teeth and dozer blade into the
ground.
2. Move the hydraulic lockout control lever to the locked
(closed) position.
3. Turn the key switch to OFF and remove the key.
4. Close the windows and cab door.
5. Turn the battery disconnect switch to OFF.
6. Close and lock all doors. See “Doors, Filler Cap, and
Hood” on page 5-13.
7. Securely chock (1) the tracks.
2
1
1