EasyManua.ls Logo

Sartorius Combics 2 CAIXS2 - FM APPROVALS PROJECT NO: 3049923; Specific Conditions of Use

Sartorius Combics 2 CAIXS2
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
164 Operating Instructions Combics CAIXS2
FM Certificate
FM APPROVALS PROJECT NO: 3049923
Page 3 of 10
1.3.3 ATEX Standards
Title Number Issue Date
Electrical apparatus for explosive gas
atmospheres. Part 0: General Requirements
EN 60079-0 2012
Explosive atmospheres Part 11: Equipment
protection by intrinsic safety “i”
EN 60079-11 2012
Degrees of protection provided by enclosures (IP
Code)
EN 60529
+A1
1991
2000
1.4 Listing
The product will appear in the Approval Guide, an on-line resource of FM Approvals, as
follows:
1.4.1 US Listings
Hazardous Location Equipment - United States Indicators Digital
CAIXS2-ab Intrinsically Safe Indicator
IS / I, II, III / 1 / ABCDEFG / T4 – Entity 66015-751-07
I / 1 / AEx ia IIC / T4 Entity 66015-751-07
21 / AEx ia IIIC / T80°C Entity 66015-751-07
a = U or V or blank
b = blank or up to three numbers (not relevant to safety)
Specific Conditions of Use
1. The front panel of the intrinsically safe indicator type CAIXS2-…. is non-metallic
and shall not be used where UV light or radiation may impinge on the enclosure.
2. The device shall be installed in such a way that it is protected against the entry of
solid foreign objects or water capable of impairing the safety of the apparatus. Reduce
the risk of mechanical damage to a minimum.
3. After the first installation, the gasket must be replaced each time the enclosure is
opened.
Electrical Parameters
Connections to the DC Supply Adapter Cable
Circuit Ui Ii Pi Ci Li
V_1 12.6 V 133 mA 1.46 W 188 nF 0.0 mH
V_2 12.6 V 133 mA 1.46 W 3 nF 0.0 mH
V_3 8.6 V 187 mA 1.51 W 391 nF 0.0 mH
V_4 12.6 V 150 mA 1.68 W 223 nF 0.1 mH
Connections to the Data Adapter Board (COM1)
Circuit Ui Ii Pi Ci Li
RS232 12.6 V*/25.2 V** 328 mA*** any 2.2 nF*/0.5nF** 0 mH
RS422 8.6 V 210 mA 0.5 W 0.5 μF 0 mH
RS485 see below see below any 260nF 0 mH
Digital I/O 8.6 V any any 0 μF 0 mH
*: versus ground; **: between the lines; ***: resistively limited

Table of Contents

Related product manuals