356
The media will be fed up to the tear-off edge after printed. Then the printer, after receiving
next print data, will back feed the next label to the print head position.
(2) Cutter (Head position)
The printer will back feed the label up to the print head position immediately after the last
label is cut.
(3) Cutter (Cutter position)
The printer, after receiving the next print data, will back feed the media to the print head
position.
(4) Cutter (No back feed)
No back feed.
(5) Linerless cutter operation (cutting position)
The mode performing following operation that receive print data, then backfeed to the
printhead position, after that print and cut the label after completing printing.
(6) Dispense (Head position)
Back feeds the labels to head position after dispensing.
(7) Dispense (Dispense position)
The media will be fed up to the head position after data receiving and the label will be fed to
the dispenser position after printing.
(8) Cut (Cut position + Cut during print)
When receiving print data, the printer cuts the last label while printing a label.
Parent topic System Command
To Next Page
Loading...
Need help?
General
Weight and Dimensions
