SATO CL4NX - Page 432

430
[Valid command]
<X20> <X21> <X22> <X23> <X24> <XM> <XS> <XU> <XB> <XL>font
<RH>
<B> <BC> <BG> <BI> <D> <BD> Barcode
<2D10> <2D12> <2D20> <2D30> <2D31> <2D50> <DN> <DS>
[Supplemental explanation]
• If you specify reading data and start use (<TU>1), specify cancel use (<TU>0) within the same
print job if.
• Only one pair of this command (<TU>1, <TU>0) can be specified in one print job.
• This command cannot be specified together with sequential printing or registering formats.
• You cannot specify multiple labels for print jobs that include this command. Even if you specify 2
or more labels with <Q> command, it will be interpreted as 1.
• This command cannot be used in combination with other RFID commands.
• When you specify the user ID by using <DN> in the data part during the use of 2D codes,
specify the number of characters of the user ID in the number of data items.
Example:
<TU>1,01000007SATO
<DN>0004,SATO
• This command will not be executed while the printer is printing. It will be executed after the print
is complete.
• This command is enabled in sequential printing, cutter (backfeed after print), dispenser
(backfeed after print).
It cannot be used in tear-off mode, cutter (backfeed before print) and dispenser (backfeed
before print).
• This command will not work correctly if the tag offset is set anywhere other than default position.