EasyManua.ls Logo

SATO CL4NX - Page 496

SATO CL4NX
756 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
494
Parameters related to write block list (omissible)
Cannot be used together with parameters related to
NFC(NDEF).
Parameters related to subtraction register (omissible)
rga: Specify the subtraction register A. Set a decimal from 0~4,294,967,295.
The register value for inlet shipping is 4,294,967,295.
Write is possible only when the setting value is below
the value stored in the register.
*1
rgb: Specify the subtraction register B. Set a decimal from 0~4,294,967,295.
The register value for inlet shipping is 4,294,967,295.
Write is possible only when the setting value is below
the value stored in the register.
*1
rgc: Specify the subtraction register C. Set a fixed 16-digit hexadecimal. Specify an even
number for the number of digit.
The hexadecimal for inlet shipping is
FFFFFFFFFFFFFFFF.
This register without subtraction function is regarded
as normal memory.
*1 When writing a value larger than the original data in subtraction register A or B, VERIFY TAG
ERR error will occur.
Parameters related to individualized master key (omissible)
* Specify this parameter to automatically set the individualized card key based on the card key block.
(Set different key for each card)
sdk: Specify the individualized master
key.
Set a fixed 48-digit hexadecimal.
The individualized card key cannot be set if omitted.
Note:
• If the individualized master key leaks out, the "individual
key" for all cards can be created easily. As such,
manage and use the individualized master key in a fully
secured environment.
Parameters related to card key version (omissible)
ckv: Specify the card key version. Set a fixed 4-digit hexadecimal.
With sdk: specified and ckv: omitted, the card key
version is written as 0000.
Parameters related to data format code (omissible)
Note:
• A parameter error will occur if df1: and df2: are specified together.
• df2: can be used only for FeliCa Lite.
df1: Data format
code case 1
Set a fixed 4-digit hexadecimal.
Even if this parameter is specified, the data is written to the ID block
only. The IDm of Polling response is not changed as shown below.
E.g.:

Table of Contents

Other manuals for SATO CL4NX

Related product manuals