SATO CL4NX - Page 506

504
<A>
<V>50<H>50<BD>3020654912345678904
<RK>4,D0,,nfc:1,ndf:1,ptl:1,ndd:8,sato.com
(1) (2) (3)
<Q>1
<Z>
Memory data after execution NFC(NDEF) message
(Note: 1 block= 16 bytes)
Block
Data
Byt
es
position
Format
Data
0
0
Record
header
Record
information
0xD1
1
.
.
.
13
NFC(NDEF)
message
1
Number of
characters in the
format
0x01
2
Number of bytes in
the payload
0x09
3
Format(1)
0x55[U]
4
Payload
Protocol
number(2)
0x01
(http://www.)
5
Resource data(3)
0x73[s]
6
0x61[a]
7
0
x74[t]
8
0x6F[o]
14
9
0x2E[.]
10
0x63[c]
11
0x6F[o]
12
0x6D[m]
U
ser memory area
[Notes]
• This command allows printing for continuous printing, cutter printing, dispenser printing and
tear-off.
• This command cannot be specified multiple times in between <A>(start of data transmission)
through <Z>(end of data transmission). Neither can it be specified together with <IP0>(EPC
code write) command.
• Contents of sequential printing or calendar cannot be written as information to the tag
• The sent information and written information are verified before printing when information is
written to tag with this command.
• The default value of parameter b is 0 (stop without ignoring tag error).
• If printing object doesn’t exist for the print job that includes this command, printer only writes for
RFID and doesn’t feed label. The buzzer will sound 6 times if it fails to write to tag. If successful,
the buzzer is sounded 2 times but does not feed the label. If you want to feed or print as blank
label specify 1 for the “fsw: feed without printing” field.
• Refer to the following chart if you want to specify the alphabet “A” in ASCII/HEX data formats.
Mode ASCII HEX
Data 'A' "41"
Code 41H 34H,31H
Parent topic RFID Command (CL4NX Only)