6 Installation of Options
105
S84-ex/S86-ex Service Manual
11
Insert the antenna wire of the UHF
standard antenna assembly through
the opening on the printer frame as shown.
Pull out the antenna wire from the PCB side.
12
Insert the UHF standard antenna
assembly to the arrow direction. Fit the
projecting part of the printer into the slot of
the UHF standard antenna assembly
as shown.
Make sure that the antenna wire is arranged on the
grove of the center frame. Lightly pull the antenna
wire from the other end to prevent excess length of
wire.
13
Attach the UHF standard antenna
assembly to the chassis using a
screw .
14
Remove two screws (print head) and
the head cover
from the
print head
.
The serial label of the print head is pasted on the
head cover
. Keep the head cover for
future reference.
To Next Page
Loading...
