6 Installation of Options
107
S84-ex/S86-ex Service Manual
17
Connect the print head cables to two
connectors of the RFID print head
assembly .
18
Pass the antenna wire of the RFID
print head assembly through the
hole of the printer center frame, following
the routing of the print head cables.
Pull out the antenna wire from the PCB side.
19
Pull back and arrange the cables from
the top of the print head assembly.
20
Install the RFID print head
assembly
.
Align the print head and press the print head
upward until it is latched.
21
Attach the cover back to the top of the
print head assembly using the
thumbscrew .
CAUTION
When attaching the cover, be careful not to pinch the
cable.
Go through
this hole
11
20
19
19
20
print head
cables
To Next Page
Loading...
