SATO S84 ex - Page 110

6 Installation of Options
108
S84-ex/S86-ex Service Manual
22 Pass the antenna wires,  and , through
the cable clamp  as shown.
For thermal transfer printer
(For direct thermal printer, skip step 23 and step 24,
and proceed to step 25.)
23 Remove the screw  and attach the cable
clamp  using the screw  again.
24 Bind the antenna wires,  and , using
the cable clamp .
For direct thermal printer
(For thermal transfer printer, skip step 25 and step 26,
and proceed to step 27.)
25 Remove the cable saddle  and shift it to
the center position of the gearbox.
26 Bind the antenna wires,  and , using
the cable saddle .
12
21
20
12
22
23
20
21
20
23
12