6 Installation of Options
110
S84-ex/S86-ex Service Manual
29
Connect the RFID signal cable from
the RFID module assembly to the
main (CONT) PCB .
Connect the connector with a looped wire to the
main (CONT) PCB as shown.
30
Connect two antenna wires, and ,
to the RFID module assembly .
Take note on the position of the antenna wires
as shown. Connect the antenna wire from the
print head to the ANT2 connector. Connect the
antenna wire from the UHF standard antenna
assembly to the ANT1 connector.
31
After connection, fix the antenna wires
using the cable saddle as shown.
32
Attach the pressure roller plate to the
printer using the thumbscrew .
33
Push the center of the pressure roller
plate to latch it in place.
24
26
CAUTION
From UHF
standard antenna
assembly
From print
head
27
28
20 12
To Next Page
Loading...
