SATO WS412DT - ESC+BQ QR Code

134
2D Code
Available for
WS4 series
ESC+BQ QR Code
ESC+BQ
Hex code
ESC
BQ
Parameter
<1B>16
<42>16<51>16
Manual setup abcc,(ddeeff,)g(hhhh)n
Auto-setup abcc,(ddeeff,)n
Default setting
None
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Specifies QR code
[Format]
Manual setup <BQ>abcc,(ddeeff,)g(hhhh)n
Auto-setup <BQ>abcc,(ddeeff,)n
●Parameter
a Error correction level = 1 : 7% High density (L)
2 : 15% Standard (M)
3 : 30% Ultrahigh reliability (H)
4 : 25% High reliability (Q)
b Concatenation mode = 0 : Normal mode
1 : Concatenation mode
c Size of one side of cell = Valid range : 01 to 32 dots
Example) cc=04
d Quantity of partitions by concatenation mode = Valid range : 01 to 16
e Sequential number partitioned by concatenation = Valid range : 01 to 16
f Concatenation mode parity data = Valid range : 00 to FF
g Input character mode = 1 : Numeric
2 : Alphanumeric
3 : Binary
4 : Kanji
h Quantity of data = Valid range : 0001 to 7366
n Print data = Data
[Coding Example] Error correction level: 30%, concatenation mode: standard, size of one side of cell: 10
<A>
<V>100<H>200<BQ>3010,112345
<Q>2
<Z>
[Notes]
1. Parity data is a result of XOR calculation of entire data of QR Code expressed in Hexadecimal character.
2. Quantity of data is not required to specify unless character mode is set to binary.
4 dots
4 dots
Feed direction
QR Code