SATO WS412DT - ESC+CT Cut Number Unit

177
System
Available for
WS4 series
ESC+CT Cut Number Unit
ESC+CT
Hex code
ESC
CT
Parameter
<1B>16
<43>16<54>16
aaaa
Default setting
aaaa=1
Persistence of
the command
When printer is powered off
Set Parameter will not be retained.
Validity in a job
Retained until next valid setting.
Validity after a job
Set Parameter will be an default value for the next job<A>.
[Function]
Cuts label at a specified interval in a print job.
[Format]
<CT>aaaa
●Parameter
a [Number of labels between each cut] = Qty range : 0 to 9999
[Coding Example]
<A>
<V>100<H>200<P>2<L>0202<X22>,ABC
<CT>2
<Q>7
<Z>
(1) Normal (complete) cut mode
ABC
7 pcs
2 pcs
Left on printer
Complete
cut
Complete
cut
Complete
cut
Complete
cut
ABC
ABC
ABC
ABC
ABC
ABC
（＜CT＞2）
（＜Q＞7）
[Notes]
1. Valid only for cutter-mounted models.
2. If the parameter is not specified by this command <CT>, each label will be cut after printed.
3. In case the parameter “a” is set to 0, no label will be cut.
4. Set this command before <Q> command.
5. This command can not be used in combination with other cut commands <~> or <~A>.
Feed direction
Cut Number Unit