SATO WS412DT - ESC+PO Offset

189
System
Available for
WS4 series
ESC+PO Offset
ESC+PO
Hex code
ESC
PO
Parameter
<1B>16
<50>16<4F>16
abcc
Default setting
a=0,b=+,cc=00
Persistence of the
command
When printer is powered off
Set parameter will not be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Gives offset to media’s stop position on the fly.
.
[Format]
<PO>abcc
●Parameter
a [Offset] = 0 : Cutter
1 : Dispenser
2 : Tear-off
3 : Continuous
b [Offset direction] = + : Feed forward
- : Backward
c [Amount of offset] = Valid range : 00 to 99 (dots)
[Coding Example]
<A>
<PO>3+08
<Z>
[Notes]
1. This command does not need to be specified in normal use.
2. The command is to fine-tune media position when it is required by specific application.
Offset