SATO WS412DT - ESC+PG Register Printer Operation

183
System
Available for
WS4 series
ESC+PG Register Printer Operation
ESC+PG
Hex code
ESC
PG
Parameter
<1B>16
<50>16<47>16
abcdefghhijklmnooppqqrrstuvwxyz
Default setting
See table in next page
Persistence of
the command
When printer is powered off
Set parameter will be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Registers printer settings in EEPROM.
[Format]
<PG>abcdefghhijklmnooppqqrrstuvwxyz
●Parameter
See table in next page for parameter details.
[Coding Example]
<A>
<PG><00 00 02 00 00 00 00 41 01 00 00 00 00 00 00 0C 80 03 40 00 00 00 00 00 00 00 00 00 00 00>16
<Z>
Parameter shall be given in HEX <00H>16<00H>16<02H>16・・・・・・<00H>16
[Notes]
1. This command is not necessary to be specified in normal use.
2. The settings by this command will persist after turning off the printer .
Register Printer Operation