SATO WS412DT - 6 Control Command; ESC+A Start Data Transfer

10
6. Control Command
Control
Available for
WS4 series
ESC+A Start Data Transfer
ESC+A
Hex code
ESC
A
Parameter
<1B>
16
<41>
16
None
Default setting
None
Persistence of
the command
When printer is powered off
Command setting will not be retained.
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Start code. Data transfer defaultized.
[Format]
<A>
[Coding example]
<A>
<V>100<H>200<P>2<L>0202<OA>ABCD
<Q>2
<Z>
[Notes]
1. Defaultizes item. Command is used always at beginning of an item.
2. Always use data transfer start <A> and data transfer end <Z> as a set.
[Important]
1. Except for some system commands, all command settings will be set to default value.
2. If not starting data transfer with <A>, the print will not be executed.
Start Data Transfer