SATO WS412DT - ESC+W3 Default Gateway

200
System
Available for
WS4 series
ESC+W3 Default Gateway
ESC+W3
Hex code
ESC
W3
Parameter
<1B>16
<57>16<33>16
a~a
Default setting
a~a=000000000000
Persistence of the
command
When printer is powered off
Set Parameter will be retained
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Sets Default gateway.
[Format]
<W3>a~a
●Parameter
a~a [Default gateway] = 12 digits fixed
[Coding Example]
<A>
<W3>128220001001
<Z>
[Notes]
1. Place this command between <A>start code and <Z> stop code.
2. This command may not be used in combination with other commands.
3. Setting can be printed on the factory test print.
4. The set parameter will become valid after rebooting.
5. Default setting of Default gateway is as follows:
Default gateway
000000000000
[Important]
Use the valid subnet address (=consistent to the IP address currently used) for the default gateway.
Default Gateway