SATO WS412DT - ESC+~(NULL) Multi Cut

176
System
Available for
WS4 series
ESC+~(NULL) Multi Cut
ESC+~(NULL)
Hex code
ESC
~ (NULL)
Parameter
<1B>16
<7E>
16
(<00>
16
)
aaaa
Default setting
aaaa=1
Persistence of
the command
When printer is powered off
Set Parameter will not be retained
Validity in a job
Set Parameter will be retained until next valid setting
Validity after a job
Set parameter will be the default value for the next job<A>.
[Function]
Specifies the number of labels to print between each cut.
[Format]
<~(NULL)>aaaa
●Parameter
a [Number of prints before cutting] = Valid range : 0 to 9999
[Coding Example]
<A>
<V>100<H>200<P>2<L>0202<OA>ABC
<Q>4
<~>2
<Z>
(1) Normal cut mode
ABC
4 pcs
2 pcs
Complete cut
Complete cut
Complete cut
Complete cut
ABC
ABC
ABC
ABC
ABC
ABC
ABC
1. Valid only for Cutter models.
2. If this command is not specified in Cutter mode, each label will be cut off after printed.
3. In case the parameter “a” is set to 0, no label will be cut.
4. The product of Qty and value of “aaaa” shall not exceed the maximum number “999999”.
5. This command <~> shall be put after Qty<Q>. <Q>, in this case, is to specify number of sheets to be cut.
6. This command may not be used in combination with other cut commands, <CT> or <~A>.
Label feed direction
Multi Cut