SATO WS412DT - ESC+LD User Download

188
System
Available for
WS4 series
ESC+LD User Download
ESC+LD
Hex code
ESC
LD
Parameter
<1B>16
<4C>16<44>16
, a, b, c, d, e, f, g, h, i, j
Default setting
See table below
Persistence of the
command
When printer is powered off
Set Parameter will be retained
Validity in a job
Retained until next valid setting
Validity after a job
Retained until next valid setting
[Function]
Settings of : Auto-online, zero slash(Enable/Disable), protocol code, Euro code
[Format]
<LD>,a,b,c,d,e,f,g,h,i,j
● Parameter
See the table below.
Function
Parameter
Description
Default
Standard
Non-standard
Protocol code
a(HEX)
STX
02H
{(7BH)
b(HEX)
ETX
03H
}(7DH)
c(HEX)
ESC
1BH
^(5EH)
d(HEX)
ENQ
05H
@(40H)
e(HEX)
CAN
18H
!(21H)
f(HEX)
NULL
00H
~(7EH)
g(HEX)
Offline
@(40H)
](5DH)
Auto-online
h(ASCII)
0: YES 1: NO
0(30H)
0(30H)
Zero slash
i(ASCII)
0: YES 1: NO
0(30H)
0(30H)
Euro code
j(HEX)
D5H
D5H
D5H
[Coding Example]
<A>
<LD>,{,},%,#,&,=, - ,0,0,<FF>
16
<Z>
[Notes]
1. Place this command between Start code<A> and Stop code<Z>.
2. The command <LD> may be received while printer is in online mode.
3. Certain parameters may be omitted by giving “,” as place holder. Current valid setting will be applied to “,” position.
4. If more or less than 10 commas “,” is used, or specified code is used in other commands or in print data, the result may not be guaranteed.
5. After the setting by this command <LD> is successfully completed, setting information will be printed.
After the printing is completed, press the FEED/LINE key once and repower the printer to make the new settings valid. If the printer is powered off
without FEED/LINE key pressed, the setting information will not be saved.
6. Non-standard code set by this command <LD> will be enabled by the command <PG> or <PC>.
User Download