SATO WS412DT - ESC+WK Job Name

14
Control
Available for
WS4 series
ESC+WK Job Name
ESC+WK
Hex code
ESC
WK
Parameter
<1B>
16
<57>
16
<4B>
16
aaaaaaaaaaaaaaaa
Default setting
aaaaaaaaaaaaaaaa=<20>
16
Persistence of
the command
When printer is powered off
Set parameter will not be retained
Validity in a job
Set parameter will be retained until next valid setting
Validity after a job
Becomes invalid after the job
[Function]
Defines job name for status return
[Format]
<WK>aaaaaaaaaaaaaaaa
● Parameter
a [Job name] = ASCII-CODE 16 digits
[Coding example] Job name: SATO
<A>
<WK>SATO
<V>200<H>100<P>0<$>B,100,100,6
<$=>SATOPRINTER
<Q>2
<Z>
[Notes]
1. If using the status 4 as transfer protocol, the job name can be set in the telegram.
2. The status can be confirmed by putting out a status request (ENQ).
3. This command is set within the item, between start data transfer <A> and end data transfer <Z>.
4. This command can be used together with Define job ID number <ID>.
[Tips]
1. Activates when status return transfer protocol is used and status request (ENQ) is received during printing (incl. QTY≠0, offline,
error).
2. If status return transfer protocol is used, and status request is received while not printing (QTY=0, start up, no data received),
space (20H) will be set and returned as status.
3. If defining a job ID name several times during one item (between start data transfer <A> and end data transfer <Z>), the last
definition will be valid.
4. For particulars, refer to the [Interface Specification].
Job Name