SATO WS412DT - ESC+Z End Data Transfer

11
Control
Available for
WS4 series
ESC+Z End Data Transfer
ESC+Z
Hex code
ESC
Z
Parameter
<1B>
16
<5A>
16
None
Default setting
None
Persistence of
the command
When printer is powered off
Command settings will not be retained.
Validity in a job
Becomes invalid after execution
Validity after a job
Becomes invalid after the job
[Function]
Stop code. Data transfer terminated.
[Format]
<Z>
[Coding example]
<A>
<V>100<H>200<P>2<L>0202<OA>ABCD
<Q>2
<Z>
[Notes]
1. Terminates item. Command is used always at the end of an item.
2. Always use data transfer start <A> and data transfer end <Z> as a set.
[Important]
1. If not ending data transfer with <Z>, the print will not be executed.
End Data Transfer