210
[Tip]
1. Details on the registration of format
A group of commands can be registered to a memory card (option). Once registered, it saves time to specify the identical command group. The
registration also allows a change of print data when recalling the format. Such function is called “Registration of Format”.
One item consists of different command groups necessary for printing, and such groups are called “Field”. Note that multiple fields make a format.
Commands for the registration of format:
One format consists of a set of commands from the Start Code <A> command to the Stop Code command <Z>, and specify the Store Format <YS>
command right after the <A> command. For the <YS> command, specify [Format number to be stored] between 1 and 999. And then, insert the Store
Field </N> command after the <YS> command to specify [Field number] and [Print digit number].
After [Field number] and [Print digit number] are entered, specify print position, character type, barcode, and so on.
[Registration Example]
Recalling the stored print contents:
Up to 999 stored formats can be specified by the Recall Format <YR> command.
To change print data, use the Print Field </D> command to specify [Field No.] to be changed, and continuously specify the changed print data.
Note that the underlined parts in the [Registration Example] are changeable.
[Example of recalling]
<A>
<CC>1
<YS>,1
</N>,1,10
<V>10<H>50
<B>2020801234567890
</N>,2,5
<V>100<H>50<L>0202<P>2
<XM>12345
</N>,3,6
<V>200<H>300<L>0101<P>2
<XM>123456
<Z>
Data to be stored in Field No.1
Data to be stored in Field No.2
Data to be stored in Field No. 3
direction
<YR>,1
</D>,2,ABCDE
<Q>2
Format storage No. to recall
Field No. of print data to be changed
To Next Page
Loading...
