91
[Notes]
1. This command supports UPC-A only. Selecting barcode type other than “H” will be a command error.
2. Recommended narrow bar width for UPC-A with HRI:
8 dot/mm resolution [02], [03]
12 dot/mm resolution [03], [04]
3. Calculate the 12
th
check digit of HRI data by using Modulus 10.
4. Refer to the following settings.
Barcode setting
5. If a parameter is specified out of the range, its behavior will not be supported.
6. The command <D> with specifying font type to print UPC-A will print the character bars all in the same length. On the other
hand, the command <BL> with font type selection will print the start bar and end bar in the same length as that of guard bars.
When printing UPC-A with command<D> followed by <font type> data, its HRI can be printed from under the start/end bar,
because the length of them is short. When printing UPC-A with command <BL> followed by <font type> data, character
spacing of the HRI will be smaller than command <BL> because the length of start and end bars is longer.
UPC-A with command <D> UPC-A with command <BL>
To Next Page
Loading...
