Translation of Original Operating Instructions
Airport Sweeper / Airport Stand Cleaner
2017-02-02 171
25 Shutdown
The following preparations must be made prior
to extended downtimes:
25.1 Vehicle
See vehicle manufacturer's operating instructions.
25.2 Auxiliary engine
See manufacturer's operating instructions.
25.3 Snow plough
See snow plough operating instructions.
25.4 Sweep and pick-up unit
Park the vehicle safely
Carry out a thorough cleaning.
Carry out a full lubrication (in accordance with
the lubrication schedule).
Protect exposed piston rods of the hydraulic
cylinders from corrosion with spray oil.
Put the cross brush into transport position.
De-rust exposed parts and coat with an anti-
corrosive substance (paint, spray oil, etc.).
Store the control panel at room temperature in
a dry, cool and dust-protected environment.
Protect electrical and hydraulic connections from
soiling. Electrical contacts are to be lubricated
with contact grease.
Treat rubber components with talcum powder or
glycerine.
Completely fill fuel tank with fuel.
Completely drain water tank, water pump and
filter system. Blow out water lines with
compressed air. Lower the brush in this case,
shut off the water and remove the water filter,
switch on the spray nozzles, open the shut-off
valve and close again after emptying. Fill water
pump with a bio-degradable oil emulsion and turn
pump a few times. Drain the compressed air tank
using the drain valve.
Remove the battery, check acid levels and charge
every 3 months.
To Next Page
Loading...