Translation of Original Operating Instructions
Airport Sweeper / Airport Stand Cleaner
2017-02-02 23
4.6.3 Reversing
If the driver cannot see the space to the rear, a guide
must be used.
4.6.4 Unloading the hopper
If the driver cannot see the space to the rear when
emptying the hopper, a guide is to be used.
4.6.5 Driving into junctions
If there is a machine mounted on the front which
protrudes, such as a snow plough, driving into
crossings or side roads can constitute a dangerous
situation. A guide is always to be used in these
cases.
4.6.5.1 Danger zone when steering
the machine
This data only applies when the blower, pick-up
unit and disc brush operation is switched off.
Hopper (1)
When raising the empty hopper, a distance of 10 m
to the rear and 3 m from the side is to be maintained.
Pick-up unit (2)
Control is to be relinquished immediately if
somebody steps into the raising and lowering area.
People must keep a distance of 2 m to the rear and
the side.
Blower fan direction (3)
Control is to be relinquished immediately if
somebody steps into the raising and lowering area
of the blowing equipment (1). A distance of 2 m must
be maintained.
Disc brush (4)
Control is to be relinquished immediately if
somebody steps into the raising, lowering and
pivoting area of the disc brush (2). A distance of 2 m
must be maintained.
Front-mounted machine (5)
If a mounted machine is attached, its operating
instructions are to be observed.
To Next Page
Loading...