Translation of Original Operating Instructions
Airport Sweeper / Airport Stand Cleaner
2017-02-02 49
7.14.3.1 Spray beam above leaf filter
The spray beam (2) can be used to clean the hopper
interior and the leaf filter when the blower is switched
off.
Start the auxiliary engine.
Open container doors.
Turn the ball valve towards the rear (3)
Press button (4). The pump speed is increased
to max. 800 rpm.
The spray unit is switched on and the hopper
is rinsed out.
After cleaning is complete, press the button (4)
again.
After cleaning, always set the ball valve (3) to
"Off" (5); otherwise debris hopper cleaning is
active.
7.14.4 Exhaust diffuser
The exhaust diffuser (1) serves to calm the upward
exhaust flow.
If contaminated (leaves, dirt particles, etc.),
the exhaust diffuser must be cleaned:
Close the debris hopper.
Set the blower to the lowest setting.
Switch the blast nozzles off if they are in operation.
Press the pneumatic valve (2) several times for
4 - 5 seconds to pivot the exhaust diffuser.
The pneumatic valve is located in the container box.
Depending on the degree of contamination,
the blower speed can be increased slightly and
the hopper cleaning can also be switched on.
2
3
4
5
1
1
2
To Next Page
Loading...