Translation of Original Operating Instructions
Airport Sweeper / Airport Stand Cleaner
2017-02-02 59
The high-pressure cleaning system is intended for
use on stubborn dirt.
Observe the pump manufacturer's operating
instructions!
Viewing glass (1)
Filling port (2)
Drainage screw (3)
Fill the water system with water
Clean filter
Open water valve.
Without water, the high-pressure water pump
switches off after 10 s.
► Rectify any faults.
If the high-pressure water pump has been operating
for more than 5 minutes, it switches off automatically
for safety reasons. If cleaning takes longer, the high-
pressure water pump can be re-started as often
as necessary.
Commissioning:
Start auxiliary engine
Press the button (1) (engine speed increases
to approximately 1100 rpm); the high-pressure
water pump switches on.
Remove the spray wand (2) from the transport
bracket and pull the hose out of the hose
roller (3).
Shutting down:
Switch off the high-pressure water pump.
Roll up hose.
1
2
3
To Next Page
Loading...