Date Code 20020501 SEL-2701 Ethernet Processor Instruction Manual
Manual Change Information
The date code at the bottom of each page of this manual reflects the creation or revision date. Date codes are
changed only on pages that have been revised and any following pages affected by the revisions (i.e., pagination).
If significant revisions are made to a section, the date code on all pages of the section will be changed to reflect the
revision date.
Each time revisions are made, both the main table of contents and the affected individual section table of contents
are regenerated and the date code is changed to reflect the revision date.
Changes in this manual to date are summarized below (most recent revisions listed at top).
Release Date Summary of Changes in this Release
This Manual Change Information section is provided as a record of changes made to this manual since the initial release.
20020501 Appendix A: Firmware Versions—Updated for new SEL-2701 release.
Appendix B: UCA2 GOMSFE Models—All UCA2 control points were made readable. Default data was set for
the UCA2 FAULT model.
20010719 Reissued entire manual to reflect the following changes:
Section 3: Settings and Commands—Updated default value of SUBNETM setting (Table 3.1 on page 3.2), added
additional discussion of Network Configuration on page 3.2, and corrected range for Telnet port settings
(Table 3.6 on page 3.7), added information on ENTXGOS setting (Table 3.7 on page 3.8).
Section 4: SEL-2030 Host—Revised Table 4.5 on page 4.5, added port parameter to description of SEL-2030
port command in Telnet From the SEL-2701 on page 4.7. Added discussion of outgoing GOOSE timing issues on
page 4.9.
Section 6: Troubleshooting—Correction, changed error code bit 8 to “Reserved for future use” in Table 6.2 on
page 6.6.
Appendix A: Firmware Versions—Updated for new SEL-2701 release.
20010425 Reissued entire manual to reflect the following changes:
Section 2: Installation—Clarification
Section 3: Settings and Commands—Corrected GOOSE sender detection logic
Appendix A: Firmware Versions—Change to SEL
BOOT Firmware Version only
Appendix B: UCA2 GOMSFE Models—Clarification
20010302 Initial Release
To Next Page
Loading...
