Date Code 20181001 SEL-3031 Instruction Manual
Settings and Commands
Commands
4.19
Access Level 2
When the device is in Access Level 2, the SEL-3031 sends the following prompt:
=>>
All of the Access Level 1 commands are available in Access Level 2. The SEL-3031
responds with Invalid Access Level when a command is entered from an access
level lower than the required level for the command. The device responds with
Invalid Command to commands that are not available or are entered incorrectly.
Access Level C
The CAL access level is used exclusively by the SEL factory and SEL field service
personnel to diagnose troublesome installations. A list of commands available at the
CAL level is available from SEL upon request. Do not enter the CAL access level
except as directed by SEL.
The CAL command allows the device to go to Access Level C . Enter the CAL
command at the Access Level 2 prompt:
=>>CAL <Enter>
ASCII Commands
The SEL-3031 includes ASCII commands and settings to properly set the SEL-3031.
QuickSet provides a user-friendly interface to set the SEL-3031, but either interface
can be used to set the product.
DATE Command
Use the DATE command to view and set the date, as shown in Table 4.9.
The device can overwrite the date entered with other time sources, such as IRIG. Enter
DATE to set the internal clock date. Separate the month, day, and year parameters with
slashes. Set the year in four-digit format (for dates 2000–2099).
Table 4.9 DATE Command
Command Description Access Level
DAT Displays the internal clock date. 1
DAT date Sets the internal clock date (DATE_F set to MDY,
YMD, or DMY).
1
To Next Page
Loading...
