Date Code 20181001 SEL-3031 Instruction Manual
Settings and Commands
Commands
4.21
If no IRIG-B code is present at the serial port input, or if the code cannot be read
successfully, the device will respond as follows:
IRIG-B DATA ERROR
=>
L_D Command
Use L_D to load firmware, as shown in Table 4.12. See Appendix A: Firmware and
Manual Versions for information on firmware and instruction manual changes.
PASSWORD Command
Use PAS to view or change existing passwords, as shown in Table 4.13 and Table 4.14.
This device is shipped with default passwords. Default passwords should be changed to private
passwords at installation. Failure to change each default password to a private password may allow
unauthorized access. SEL shall not be responsible for any damage resulting from unauthorized
access.
To change the password for Access Level 2 from the default password TAIL to new
password Ot3579, enter the following:
=>>PAS 2 <Enter>
Old PW:? **** <Enter> (Enter TAIL)
New PW:? ******* <Enter> (Enter Ot3579)
Confirm PW:? ******* <Enter> (Enter Ot3579)
Table 4.12 L_D Command
Command Description Access Level
L_D Downloads firmware to the device. 2
Table 4.13 PAS Command
Command Description Access Level
PAS level new passwords Sets a password for new password for
Access Level level.
a
a
Parameter level represents the device Access Levels 1 or 2.
2
Table 4.14 Factory-Default Passwords
Access Level Password
1 OTTER
2 TAIL
CAL CLARKE
To Next Page
Loading...