SEL-3031 Instruction Manual Date Code 20181001
Settings and Commands
Commands
4.26
Append s and the specific settings name you want to view in the SHOW command to
immediately jump to the setting. If s (and the settings name) is not included, the device
presents settings beginning with the first in the group.
STATUS Command
Use STA to display the status report, as shown in Table 4.22.
Refer to Section 5: Performance Monitoring, Testing, and Troubleshooting for self-test
thresholds and corrective actions, as well as information on hardware configuration
conflict resolution. Figure 4.11 shows the device response to the STA command.
=>STA <Enter>
RADIO 1 Date: 9/16/2010 Time: 04:29:13
STATION_A Time Source: Internal
Serial Number: 000000000000000
FID=SEL-3031-R101-V0-Z002001-D20100723 CID=8BCE91D9
RFID=SEL-3031-R101-V0-D20101630
BFID=SLBT-3031-R100-V0-Z000000-D20091009
Part number 30310W01XXX
Radio Link
LINK RSSI AVAILABILITY
YES -29 dBm 99.63 %
Radio Configuration
NETWORK MODE NID SYNC
P2P MASTER 5 OFF
PORT 1 PORT 2 PORT 3
STANDARD STANDARD STANDARD
19200 19200 19200
SELF TEST RESULTS
FLASH OK SDRAM RTC SEC
OK OK OK ABSENT
Table 4.21 SHO Command (Show/View Settings)
Command Description Access Level
SHO G s Show Global settings 1
SHO R s Show Radio settings 1
SHO P s Show serial Port settings 1
Table 4.22 STA Command (Device Self-Test Status)
Command Description Access Level
STA n Displays the device self-test information n times
(n = 1–32767). Defaults to 1 if n is not specified.
1
STA C Reboots the device and clears self-test warning and
failure status results.
2
To Next Page
Loading...