Date Code 20181001 SEL-3031 Instruction Manual
Settings and Commands
Commands
4.27
Device Enabled
=>
Figure 4.11 Device Response to the STATUS Command
Table 4.23 shows the status report definitions and message formats for each test.
TIME Command
Use TIME to return information about the SEL-3031 internal clock, as shown in
Table 4.24. You can specify hours and minutes (seconds data are optional). Separate
the hours, minutes, and seconds with colons, semicolons, spaces, commas, or slashes.
Enter TIME hh:mm and TIME hh:mm:ss to set the internal clock time. The value hh
is for hours 0–23; the value mm is for minutes 0–59; the value ss is for seconds 0–59. If
you enter a valid time, the device will update, save the time in nonvolatile memory, and
display the time entered. If you enter an invalid time, the SEL-3031 will respond with
Invalid Time.
Table 4.23 STA Command Report
Status Report
Designator
Definition Message Format
FID Firmware identifier string Text Data
RFID FPGA Firmware identifier string Text Data
BFID SEL
BOOT Firmware identifier string Text Data
Part Number Part Number of the SEL-3031 Text Data
PORT 1, 2, 3 Protocol setting for Port 1, 2, and 3 STANDARD, MB8, MODBUS
FLASH Nonvolatile memory integrity OK/FAIL
SDRAM Integrity of code that runs in RAM OK/FAIL
RADIO Radio module status OK/FAIL
RTC Real-Time Clock status OK/FAIL
SEC SEL-3044 Encryption Card status OK/ABSENT/RESET/FAIL
Table 4.24 TIME Command Definitions
Command Description Access Level
TIME Displays the present internal clock time. 1
TIME hh:mm Sets the internal clock to hh:mm. 1
TIME hh:mm:ss Sets the internal clock to hh:mm:ss. 1
To Next Page
Loading...