SEA SYSTEMS
INSTALLATION AND USE MANUAL
CONTROL PANEL and PREWIRED SYSTEM STK1
For Electric and Hydraulic Lifts
MSTK12-GB
Rev.01
30/12/05
SETRONIK1 Pagina 20 di 54
2.7.4. F
IXING AND CONNECTION OF THE SHAFT SENSORS FOR ELECTRIC LIFTS
The shaft sensor kit can be of two different type according to the type of brackets used for
sensors and magnets as the following tablet.
The tablet reports also the code of the diagram of the shaft sensor disposition included in
this paragraph.
SENSORS AND MAGNETS A TYPE
KIT BRAKET
B TYPE
KIT BRAKET
Sensors IS, ID CVF IS, ID
Sensors SR, DR CRF SR, DR
Two round magnet couples for the stop MVF No Bracket
Round magnet couple for speed-change in upward MVR-IS No Bracket
Round magnet couple for speed-change in downward MVR-ID No Bracket
Round magnet couple for speed-change at the upper floor MVR-SR No Bracket
Round magnet couple for speed-change at the lower floor MVR-DR No Bracket
Diagram for sensor and magnet disposition
Æ
See diagram
CVFA
See diagram
CVFA
HIGHLIGHT
We recommend that you choose A System for the installation of magnets. The
system ensures tighter fastening of the magnets, a better magnetic field, less
exposure to various bodies (grease, iron fillings….)
With the B System, the magnets without bracket have to be fixed directly on the
guide.
To Next Page
Loading...
