ENGINE TOP END
3-5-38
◆
Record the 3 digit number on the bottom of the
tappet
【
A
】
.
◆
Reference the valve clearance measurement
recorded for that valve, along with the 3 digit tappet
number.
◆
Refer to the appropriate tappet selection matrix
(Intake or Exhaust) on the following pages and
select the proper tappet.
◆
Install the proper tappet.
◆
Repeat the above steps until all necessary valves
have been adjusted.
◆
Reinstall the camshafts and camshaft carriers and
tighten the bolts evenly to specifi cation.
◆
Tighten:
Torque
Bolts (M6)
9.8 N•m (1.0kgf•m, 87in•lb)
◆
Measure and confirm that valve clearance is now
within specifi cation for each valve.
If valve clearance is not within specifi cation, repeat this
procedure.
If all valve clearance measurements are now within
specifi cation, remove the camshaft carriers and proceed
to Camshaft Installation / Timing.
A
To Next Page
Loading...
